Operating Instructions; Mounting The Bicycle Rack; Mounting The Wheel Rails; Mounting The Lamp Mount - EUFAB 11559 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

The bicycle rack must fi rst be assembled. Take all of the components out of the packaging and set them out clearly. Every stage is described and
clearly shows which components are required for the assembly of the rack.

6.1 MOUNTING THE BICYCLE RACK

Step 1
Components:
Cross-headed
screw Cross-headed
screw
M5 x 35
M5 x 12

6.1.1 MOUNTING THE WHEEL RAILS

Place the wheel rail halves, with the plastic shells on the outside, parallel on the base frame so that
the drilled holes in the rail match the holes in the base frame. Secure each wheel rail to the base frame
with the two lock screws M6 x 50, washers and self-tapping nuts M6.

6.1.2 MOUNTING THE LAMP MOUNT

Join the two halves of the lamp mount together. This is made easier by the small guide
element which is already mounted on one side. Push the rails together and secure the
connection with the cross-headed screw (M5x12) and washer.
Insert the cross-headed screws M5 x 35 with spring washers and washers, from below,
through the vertical drilled holes of the lamp mount. Insert the screws through the threaded
holes on the underside at the end of the lamp mount. Tighten the screws.
Make sure that the fog light is installed on the left side of the mount!
Step 2
Components:

6.1.3 MOUNTING THE U-BRACKET

Place the U-bracket on the U-bracket mount of the base frame. Secure the U-bracket with the supplied lock screws (M8 x 60), washers and knob
nuts M8. The knob nuts must be mounted on the inside.
CAUTION
You must tighten both knob nuts very fi rmly to ensure that the U-bracket is fl ush against the U-bracket mount
10
Base frame
Result of Step 1
U-bracket
Wheel rail halves
Lamp mount set
Lock screw
M8 x 60
Knob nut
M8
Lock screw M6 x 50
Frame holder