Mounting The Frame Holder; Mounting The License Plate Holder; Laying The Electrical Cables; Mounting The Short Tensioning Strap - EUFAB 11559 Manuel De L'opérateur

6.1.4 MOUNTING THE FRAME HOLDER

Undo the handle screw of the frame holder and rotate out fully. Open the cuff of the frame holder and place
the inserts around the U-bracket at a position suitable for your bicycle. Place the cuff around the inserts and
push fi rmly together. Close the frame holder using the handle screw (but do not tighten).
Step 3
Components:

6.1.5 MOUNTING THE LICENSE PLATE HOLDER

Remove the screws from the lamp mount before installing the license plate holder and then mount the license plate holder. The license plate
holder must be at the same height as the lights.
Inserting the license plate
The mounting clips for securing the license plate are push-out parts in the holder.
Break out two of the clips. Slide the license plate into the holder, then push the clips
into the cut-outs to secure the license plate.

6.1.6 LAYING THE ELECTRICAL CABLES

Secure the cables of the lights to the underside of the rack using the supplied cable ties. Make sure that the cables cannot be damaged during
travel.

6.1.7 MOUNTING THE SHORT TENSIONING STRAP

Insert the short tensioning strap from the inside to the outside below the bike holder and then from the outside
to the inside through the slots of the bike holder (see photo) (see also section 6.3).

6.1.8 MOUNTING THE PLASTIC COVER

Fit the plastic covers onto the middle of the wheel rail.
Result of Step 2
Cable ties
Result of Step 3
Tensioning strap, short
Clips
License plate holder
Plastic cover
Cut-outs Cut-outs
11