Publicité
1 4
1
2
3
4
36
Balancing relative volume between speakers
using Test Tone
3
2
Speaker Configuration 3
The test tone function is useful to adjust the relative volume
between speakers.
Once the balance is set, you don't have to change the balance
as long as the speakers aren't moved.
< It is also possible to adjust the relative volume during playback
of DVD. See 48 page for details.
< Use the remote control from your listening position.
< The T.TONE button will not work when the SPEAKER button is
set to off. In that case, press the SPEAKER button to turn the
speakers on.
< The T.TONE button will not work when 6CH DIRECT is selected.
In that case, press the 6CH DIRECT button to turn it off.
1
Press the T.TONE button.
The test tone is emitted from each speaker in the following
order at 2-second intervals.
FL
C
FR
< If certain speakers are not being used, (for example, no center
speaker) the noise sequencer will automatically skip over that
channel.
2
Adjust the master volume to the normal listening level.
3
Adjust the volume of each speaker so that the test tone from
each speakers sounds the same.
< The level of the speaker emitting the test tone can be changed
by pressing the LEVEL buttons.
< The level can be adjusted in 1 dB steps from -15 dB to +15 dB.
4
When the setting has been finished, press the T.TONE button
to stop the test tone.
ENGLISH
SR
SL
SW
Publicité
