Publicité
1
1
2
3
4
60
3
2
4
Tuner
1
Select TUNER by turning the FUNCTION knob (or press the
TUNER button of the remote control unit).
Make sure the antennas have been connected (see page 6~8).
2
Select AM or FM by pressing the BAND button.
< If the BAND button is pressed while the source other than
TUNER was selected, the source will be switched to TUNER
automatically.
3
If "PRESET" indicator is lit, press the TUNING MODE button to
select the manual tuning mode.
The "PRESET" indicator disappears from the display.
This button is used to change the tuning mode.
< When using the remote control unit, you can skip this step.
4
Select the station you want to listen to (auto selection).
Hold down the TUNING/PRESET button (or the SELECT button
of the remote control unit) for more than 0.5 seconds.
When a station is tuned in, the tuning process will stop
automatically.
If you want to stop the tuning process, press the
TUNING/PRESET button.
Selecting stations which cannot be tuned automatically
(manual selection)
When the TUNING/PRESET button is pressed momentarily (0.5
second or less), the frequency changes by a fixed step.
FM : 50 kHz steps
AM : 9 kHz steps
Press the TUNING/PRESET button repeatedly until the station
you want to listen to is found.
< "TUNED" is displayed when a broadcast is correctly tuned in.
FM MODE Button
Pressing this button alternates between Stereo mode and
Mono mode.
Stereo:
FM stereo broadcasts are received in stereo and the "ST"
indicator lights in the display.
Mono:
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced monaural, reducing
unwanted noise.
ENGLISH
Publicité
