Publicité
3
1
2
1
2
3
TUNER*
CD
VIDEO 3
VIDEO 2
* : frequency is displayed.
la fréquence d'accord est affichée.
se visualiza la frecuencia.
4
5
40
5
4
AUX
VIDEO 1
Basic Operation 1
1
Press the POWER switch.
The unit enters standby mode, and the standby indicator lights.
2
Press the STANDBY/ON switch to turn the unit on.
The power indicator lights, and the standby indicator goes off.
3
Select a source by turning the FUNCTION knob (or pressing
one of the FUNCTION buttons of the remote control unit).
The selected source is shown on the front panel's display.
< If one of the FUNCTION buttons, 6CH DIRECT button or TAPE
MONITOR button of the remote control unit is pressed in the
standby mode, the unit is turned on with the selected source
automatically.
< If the source is connected to 6CH DIRECT INPUT jacks, press
the 6CH DIRECT button and proceed to step
Tape Monitor Function
If you want to select the source connected to TAPE MONITOR
jacks, press the TAPE MONITOR button to turn the tape
monitor function on. "TAPE M" indicator lights.
Press the TAPE MONITOR button again to cancel the tape
monitor function.
< When the tape monitor function is on, sources other than
TAPE MONITOR cannot be heard. Be sure to turn the function
off while listening to other sources.
< If the 6CH DIRECT button is pressed, the tape monitor function
will be automatically set to off.
< If a 3-head cassette tape deck is connected to TAPE
MONITOR (PLAY and REC) jacks, and if the tape monitor
function is set to on during recording, you can listen to not the
source sound but the sound being recorded.
4
When you selected VIDEO(1, 2 or 3) or CD in step
DIGITAL INPUTS button repeatedly to select the terminal.
c1: Select this when the source is connected to DIGITAL IN
(COAXIAL 1) terminal.
c2: Select this when the source is connected to DIGITAL IN
(COAXIAL 2) terminal.
o1: Select this when the source is connected to DIGITAL IN
(OPTICAL) terminal.
A: Select this when the source is connected to analog AUDIO
IN jacks.
< DIGITAL indicator blinks when the unit cannot perceive the
digital signal. In that case, connect a digital device to the
DIGITAL IN terminal, switch it on, and select the terminal by
pressing the DIGITAL INPUTS button.
< You can hear the sound from the selected DIGITAL IN terminal
as far as VIDEO(1,2 or 3) or CD has been selected in step
5
Play the source, and gradually turn up the volume to the
required level by turning the VOLUME knob.
ENGLISH
5
.
3
, press the
3
.
Publicité
