Publicité
1
2
3
56
DOLBY PRO LOGIC II parameters
You can adjust the parameters for DOLBY PRO LOGIC II MUSIC or
DOLBY PRO LOGIC II CUSTOM.
1
Select DOLBY PRO LOGIC II MUSIC or DOLBY PRO LOGIC II
CUSTOM by pressing the DSP button.
2
Select the parameter to be changed by pressing the PL II
PARA button.
Each time the PL II PARA button is pressed, the parameter is
changed as follows:
Dolby Pro Logic II Music
PANO
Dolby Pro Logic II Custom
PANO
BAL
PO-I
3
Within 5 seconds, press the SELECT button to change the
value.
PANO (panorama):
This mode extends the front stereo image to include the
surround speakers for an exciting wraparound effect with
side wall imaging. Select "ON" or "OFF".
The default setting is "OFF".
C-WID (center width control):
This adjusts the center image so it may be heard only from
the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying
degrees.
The adjustable range is from 0 to 7. The default setting is "0".
DIMEN (dimension control):
This adjusts the sound-field either towards the front or
towards the rear. The adjustable range is from -4 to +2. The
default setting is "0".
LPF (7 kHz Low Pass Filter on the surround channels):
Select "ON" or "OFF".
SH-F (Shelf Filter on the surround channels):
Select "ON" or "OFF".
PO-I (Right Surround Channel Polarity Inversion):
Select "ON" or "OFF".
BAL (Automatic Balancing):
Select "ON" or "OFF".
< In the Dolby Pro Logic II Music mode, you cannot select the 7
kHz Low Pass Filter, Shelf Filter, Right Surround Channel
Polarity Inversion and Automatic Balancing.
< 7 kHz Low Pass Filter and Shelf Filter cannot be set to "ON"
simultaneously. If you try, the filter set previously is
automatically changed to "OFF".
Repeat step
2
and
3
to adjust other parameters.
When all the configurations have been finished, leave the unit
idle for 5 seconds to exit.
ENGLISH
C-WID
DIMEN
C-WID
DIMEN
SH-F
LPF
Publicité
