Ingersoll Rand UP5S 11 Installation, Exploitation Et Maintenance page 8

OPERATING INSTRUCTIONS (XE-70M CONTROLLER)
USER INTERFACE

The standard user interface configuration of the
controller consists of the membrane and the LCD display��
The membrane consists of five command keys (Start,
Stop, Load, Unload, and Reset), four navigation keys
(Up, Right, Left and Down), and an Edit mode selection
key (Enter)�� These keys, in conjunction with the graphics
display and the LED icons, make up the user interface to
the compressor��
Figure 1: Xe-70M
LED STATUS ICONS

Three LED icons are used to indicate the current status of
the control system from a distance and are located on the
upper left side of the user interface��
Table 1: Xe-70M LED Status Icons
Icon Name Function
OK Illuminates when no Warnings or
Trips are sensed�� Can be in a Ready
or Not Ready state�� This icon will
flash when the machine is Running
Unloaded��
Alert Illuminates when a Warning
(flashes) or Trip (constant ON)
is sensed�� Can be in a Ready
(Warning) or Tripped state��
Auto Illuminates when the compressor
stops in auto restart��
COMMAND KEYS

These keys command the controller to perform actions as
specified in the following table�� When any of these keys
are pressed the action below will be initiated and logged
in the event log��
Table 2: Xe-70M Command Keys
Icon Name Function
Load Puts the compressor into the
selected mode of operation��
Unit will load if the pressure
conditions are right��
Unload Puts the compressor into an
unloaded state�� Unit will run
unloaded indefinitely��
8
RELEASED 20/Jul/2016 17:56:55 GMT
All manuals and user guides at all-guides.com
Icon
The Load and Unload keys are not used on the
variable speed compressors��
NAVIGATION KEYS

There are four navigation keys (UP, RIGHT, DOWN and
LEFT)�� While the ENTER key is not considered a navigation
key, it is used in conjunction with the navigation keys to
make or confirm a selection��
The navigation keys roll over�� Pressing one of the
navigation keys will lead the user down a navigation path��
Each time the key is pressed, another step in the path
is taken�� Once the end of a navigation path is reached,
pressing the key one more time will bring the user back
to the beginning of the path�� Pressing the opposite
key will move the user through the navigation path in
the opposite direction�� Once the beginning is reached,
pressing the opposite key will take the user to the end of
the path��
DISPLAY LAYOUT

Name Function
Reset Clears Warnings and Trips once
the fault condition is corrected��
Start Starts the compressor��
Stop Stops the compressor�� This
button should be pressed
instead of the Emergency Stop
for normal stopping operation��
Enter Toggles the display between the
Navigation mode and the Edit
mode��
NOTICE
Figure 2 : Navigation Keys
Figure 3 : Display Layout
A
B
C
D
80448418 Rev.C