Ingersoll Rand UP5S 11 Installation, Exploitation Et Maintenance page 26

7�� Replace plug in drain valve��
8�� Refill the machine following the "top up coolant"
procedure above�� After initial fill, to purge any
airlocks, the machine should be run for a few
minutes cycling between load and no load, before
checking that the level is correct��
9�� Replace and tighten coolant fill cap��
COOLANT FILTER CHANGE PROCEDURE

1�� Stop the machine, electrically isolate and vent all
trapped pressure��
2�� Loosen filter with the correct tool��
3�� Remove the filter from the housing��
4�� Place the old filter in a sealed bag and dispose of in a
safe way��
5�� Clean the mating face of the housing taking care to
avoid any particles entering the machine��
Remove the new Ingersoll Rand replacement filter
6��
from its protective package��
7�� Apply a small amount of lubricant to the filter seal��
8�� Screw the new filter down until the seal makes
contact with the housing, then hand tighten a
further half turn��
9�� Start the compressor and check for leaks��
AIR FILTER ELEMENT CHANGE PROCEDURE

1�� Stop the machine, electrically isolate and vent all
trapped pressure��
2�� Unscrew the retaining cap and withdraw the old
element��
3�� Fit the new element��
4�� Replace the retaining cap��

RELEASED 20/Jul/2016 17:56:55 GMT
All manuals and user guides at all-guides.com
MAINTENANCE
SEPARATOR CARTRIDGE CHANGE PROCEDURE

1�� Stop the machine, electrically isolate and vent all
trapped pressure��
2�� Loosen separator cartridge with the correct tool��
3�� Remove the cartridge from the housing; place it in a
sealed bag and dispose of it safely��
4�� Clean the mating face of the housing��
Remove the new Ingersoll Rand replacement
5��
cartridge from its protective package��
6�� Apply a small amount of lubricant to the cartridge
seal��
7�� Screw the new cartridge down until the seal makes
contact with the housing, then hand tighten a
further 1/4 turn��
8�� Start the compressor and check for leaks��
This unit is not designed or intended to operate
when contaminated with silicone�� Lubricants,
greases or other items containing silicone should
not be used on this unit��
COOLER CLEANING PROCEDURE

1�� Stop the machine, electrically isolate and vent all
trapped pressure��
2�� Remove the top cover to obtain access to the cooler��
3�� Clean the cooler��
4�� Rebuild in reverse order��
CAUTION
80448418 Rev.C