Publicité
Les langues disponibles
Les langues disponibles
Declaration of conformity
26 Maintenance and repair
Please observe the current safety
and accident prevention regulations
during all maintenance and repair
work.
The machine requires a minimum of care and
maintenance. Only a few items need to be
checked to ensure trouble-free long-term opera-
tion.
26.1 Check regularly
‰ Check the following points for damage before
starting up the welding machine:
– Mains plug and cable
– Welding torch and connections
– Ground cable and connection
‰ Blow the welding machine out once or twice a
year.
 To do this, switch the device and disconnect
the mains plug.
 Using dry compressed air, blow the welding
machine out from the front through the venti-
lation slots. Leave the housing closed.
Never blow the compressed air through
the ventilation holes on the rear side of
the machine. The fan is located there
and the compressed air would make
it turn so quickly that bearing damage
may result.
04.19
27 Disposal
In accordance with European Directive 2012/19/
EU on
electrical and electronic equipment waste and
its implementation in accordance with national
law, electric tools that have reached the end of
their service life must be collected separately
and returned to an environmentally compatible
recycling facility.
28 Service
Lorch Schweißtechnik GmbH
Im Anwänder 24 - 26
71549 Auenwald
Germany
Tel.
+49 7191 503-0
Fax
+49 7191 503-199
29 Declaration of conformity
We hereby declare that this product was manu-
factured in conformance with the following
standards or official documents: EN 60974-
1:2018, EN 60974-2:2017, EN 60974-3:2017, EN
60974-10:2018 CL.A in accordance with Direc-
tives 2014/35/EU, 2014/30/EU, 2011/65/EU.
2018
Wolfgang Grüb
Managing Director
Lorch Schweisstechnik GmbH
909.4169.9-03
Only for EU countries.
Do not dispose of electric tools togeth-
er with household waste material!
- 53 -
Publicité
