Certificate Of Conformity; Care And Maintenance; Check Regularly - LORCH ControlPro MicorStick 200 Manuel D'utilisation

Certificate of conformity

18 Care and maintenance

Please keep attention to the current safe-
ty regulations at all care and maintenance
works.
The machine requires minimum of care and mainte-
nance. Only a few items should be checked to ensure a
trouble free long term operation:

18.1 Check regularly

‰ Check the following points for damage before starting
up the welding machine:
– Mains plug and cable
– Welding torch and connections
– Ground cable and connection
– Keyboard membrane and control panel
 Once or twice a year please clean the machine with
dry low compressed air. Switch off the machine and
pull out the plug first. Blow the compressed air through
the front cooling ribs. Do not open the machine.
 Never blow the compressed air through the cooling
ribs at the back side of the machine, because the in-
ternal fan could be damaged.
Never blow the compressed air through the
cooling ribs at the back side of the machine,
because the internal fan could be damaged.
09.16
19 Disposal
Only for EU countries.
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU on
waste, electrical and electronic equipment and its imple-
mentation in accordance with national law, electric tools
that have reached the end of their service life must be
collected separately and returned to an environmentally
compatible recycling facility.
20 Service
Lorch Schweißtechnik GmbH
Im Anwänder 24 - 26
D-71549 Auenwald
Germany
Tel. +49 7191 503-0
Fax +49 7191 503-199
21 Certificate of conformity
We herewith declare that this product was manufactured
conform to following standards: EN 60974-1:2012, EN
60974-3:2014, EN 60974-10:2007 CL.A, conform to the
guidelines 2014/35/EU, 2014/30/EU, 2011/65/EU.
2016
Wolfgang Grüb
Director
Lorch Schweißtechnik GmbH
909.2779.9-00
- 33 -