Safety Precautions; Explanation Of Symbols; Meaning Of The Symbols On The Machine - LORCH ControlPro MicorStick 200 Manuel D'utilisation

2

Explanation of symbols

2.1 Meaning of the symbols in the
operation manual
Danger to life and limb!
If the danger warnings are disregarded, this
can cause slight or severe injuries or even
death.
Danger of property damage!
Disregarding danger warnings can cause
damage to workpieces, tools, and equip-
ment.
General note.
i
Designates useful information about the
product and equipment
3

Safety precautions

Hazard-free working with the machine is only
possible if you read the operating and safety in-
structions completely and strictly observe them.
Please obtain practical training before using
the machine for the first time. Follow the ac-
cident prevention regulations (UVV1)).
Before starting any welding work, clear away
any solvents, degreasing agents, and other
flammable materials from the working area.
Cover flammable materials which can not be
moved. Only weld if the ambient air contains
no high concentrations of dust, acid vapours,
gases or flammable substances. Special
care must be taken during repair work on
pipe systems and tanks which contain or
have contained flammable liquids or gases.
Never touch live parts inside or outside of the
housing. Never touch welding electrodes or
live welding current parts in a machine that
is on.
Do not expose the machine to rain, do not
spray water on it or steam blast it.
Always use a welding shield. Warn other per-
sons in the welding area about arc-rays.
- 20 -
2.2 Meaning of the symbols on the
machine
Danger!
Read the user information in the operation
manual.
Disconnect the mains plug!
Pull out the mains plug before opening the
housing
Please use a suitable extraction system
for gases and cutting fumes. Always wear
breathing apparatus whenever there is a risk
of inhaling welding or cutting vapours.
If the mains cable is damaged or severed in
use, do not touch the cable but unplug the
mains plug immediately. Never use a ma-
chine if the mains cable is damaged.
Keep a fire extinguisher near the welding
area.
Check the welding area for fire after welding
(see UVV*).
Never try to disassemble the pressure re-
ducer. Replace the defective one.
The machine must be transported or
set up only on firm, level surfaces.
The maximum admissible angle of inclination
for setting up or transporting is 10°.
‰ Service and repair work may only be carried out by a
trained electrician.
‰ Ensure that the ground cable has good and direct con-
tact near the welding location. Do not allow welding
current to pass through chains, ball bearings, steel
cables or grounding equipment; this may melt them.
909.2779.9-00
Safety precautions
09.16