LORCH MicorTIG 200 DC ControlPro Manuel D'utilisation page 42

16 Function and process menu
This menu can be used to select the
i
TIG or electrode processes as well as
their functions.
 Call the function and process menu by pressing
button 37 for 2 sec.
 Select the desired function or process by turning
control knob 19.
‰ Different functions are available, depending on
the process selected.
‰ Not each function / process can be combined
with any other one.
Symbol
TIG process
Pulsing function
Electrode process
CEL electrode process
Spot-welding function
Interval function
Slopes function
HF ignition function
Special 4-stroke
Tab. 1: Function and process menu
- 40 -
Description
909.4169.9-03
Function and process menu
‰ Available, not active functions or processes are
shown in pale font.
‰ A description of the symbols is provided in the
following table.
 Confirm the function or the process by pressing
control knob 19.
‰ Activated functions or processes are brightly lit
up.
‰ Close the menu and go to the previous screen
view by pressing button 37.
Mode
x x
Own set of parameters in each
x
Cannot be combined with interval
x
x
x
x
case
Only 2-stroke possible,
Not with spot welding
Touch-free ignition
04.19