LORCH MicorTIG 200 DC ControlPro Manuel D'utilisation page 47

Job mode
Fuse options
This parameter sets the mains power fuse used.
The max. selectable current is also limited at this
point.
See "Fuse options" in the following table.
Various main parameters are available, depend-
ing on the mains connection.
Power reduction
When the "Fuse power reduction (Fur) is acti-
vated, the welding current will be dynamically
reduced as required according to the fuse option
set (FuO) to prevent the main fuse from tripping.
This is indicated by the On/Off button 28 flashing
at a higher rate.
Parameter
Mains fuse
value
230 V
16A
*
16A F
13A
13A F
10A
10A F
115 V
25A
*
25A F
20A
20A F
Tab. 5: Fuse options
The "F" label indicates a fuse character-
i
istic that reduces the welding current
earlier to prevent fast fuses from trip-
ping.
19 Job mode
The "Job2 mode provides users with 2 x 10 jobs
that are independent of each other (10 jobs TIG
and 10 jobs electrode). All parameters and set-
tings made at the operating panel are stored in
a job.
The job mode can be used beneficially e.g. by
allocating frequently arising welding jobs to
04.19
Loading capacity
TIG
16A 200A
16A 200A
13A 190A
13A 190A
10A 180A
10A 180A
TIG
25A 180A
25A 180A
20A 170A
20A 170A
) Factory setting
*
specific job numbers, or different welders can
save "their" individual settings in "their" job.
Switching on job mode
i
 Press the Job button 38.
9 The display 33 shows the last used job and its
main current.
‰ You can use operating knob 19 to choose from
the stored, active jobs.
9 The Job mode ends when the Job button is
pressed again.
Save job
‰ Determine the desired welding settings.
MMA
 Press button 38 for 2 seconds.
‰ The job number is show in inverted form.
180A
 Use the operating button 19 to select the de-
180A
sired job number from 0-9.
160A
‰ An exclamation mark is shown on the left side
160A
of the job number when storage places have
already been taken.
125A
 Store the job by pressing the control knob 19.
125A
‰ Termination is possible at any tome by pressing
MMA
buttons 37 or 40.
140A
‰ When the job number is already occupied,
overwriting of the job must be confirmed.
140A
 Safety question: The job is finally transferred
125A
after confirming the "tick" symbol by pressing
125A
operating knob 19.
 Select "X" with operating knob 19 and confirm
it to terminate the job.
9 Saving of the job is thereby completed. You are
back in the previous view.
Blocking/unblocking jobs
Is used for locking a stored job.
It can then no longer be selected from the oper-
ating panel or the torch.
 Call-up the "Machine configuration" menu (see
"18 Machine configuration" on Page 43).
 Select the "Job" menu point by turning the op-
erating button 19.
909.4169.9-03
The job mode can only be switched on
if there is at least one saved, active job
present.
- 45 -