LORCH MicorTIG 200 DC ControlPro Manuel D'utilisation page 48

 Open the "Job" menu by pressing operating
knob 19.
 Select the "Lock job" menu point by turning the
operating button 19.
 Open the menu point by pressing operating
knob 19.
‰ A list of stored jobs is shown.
‰ Jobs already locked are marked with a lock
symbol.
 Select the job to be locked/unlocked by turn-
ing the operating button 19.
 Confirm the locking/unlocking by pressing op-
erating knob 19.
‰ A lock symbol is shown when a job is locked.
‰ When all stored jobs have been locked, the job
mode is automatically terminated.
9 Pressing button 37 or 40 closes a menu level.
Delete Job
Is used to delete as stored job.
 Call-up the "Machine configuration" menu (see
"18 Machine configuration" on Page 43).
 Select the "Job" menu point by turning the op-
erating button 19.
 Open the job menu by pressing control knob
19.
 Select "Delete job" by using the operating but-
ton 19.
 Open the menu point by pressing operating
knob 19.
‰ A list of the stored jobs is shown.
 Select the jobs to be deleted.
 Start the deletion process by pressing control
knob 19.
 Safety question: The job is finally deleted after
confirming the "tick" symbol by pressing oper-
ating button 19.
 Select "X" with operating knob 19 and confirm
it to terminate the job.
‰ The "Job" mode will automatically be ended
when all the jobs shown have been deleted.
9 Pressing button 37 or 40 closes a menu level.
- 46 -
20 Special functions
Master Reset
i
 Press buttons 40 and 28 simultaneously for at
least 5 seconds.
9 The display shows "Master reset" and all operat-
ing panel displays light up briefly for confirma-
tion.
21 Torch
Powermaster torch of i-LTG/i-LTW series
Torch switch functions
75 Torch switch Start/Stop
for starting and stopping the welding
process.
76 Torch switch second current
for calling up the second current.
77 Torch button Up
to increase parameter values
78 Torch button Down
to reduce parameter values
80 LED Ampere:
Lights up when the display (84) shows the
welding current.
Job LED:
81
Only possible when job mode is active,
lights up when the job number is shown.
82 Powermaster LED 3:
Can be allocated to freely selectable pa-
rameter.
Pre-set to secondary current I2.
83 Powermaster LED 4:
Can be allocated to freely selectable pa-
rameter.
Display: Presentation of the parameter
84
values.
909.4169.9-03
Caution! All personal settings will be
lost.
All stored jobs are retained!
All welding and secondary parameters
as well as the machine configuration
are reset to master reset values.
IX
Torch
04.19