Publicité
Les langues disponibles
Les langues disponibles
Secondary parameters
17 Secondary parameters
 Call up the secondary parameters by pressing
button 40.
 Set the desired secondary parameter by turn-
ing control knob 19.
‰ Not all secondary parameters will be available,
depending on the selected process, function
and operating mode.
‰ A description of the parameters in the graphic
secondary parameter menu is provided in the
following table.
 Confirm the secondary parameter by pressing
control knob 19.
 The value (III) is shown in inverted form and can
be chanced by turning control knob 19.
 Store the change by pressing control knob 19.
‰ Press button 37 or 40 to terminate a change
without storing or to exit the secondary param-
eter menu.
TIG secondary parameters
TIG secondary parameters
2
A Gas pre-flow time
B Start energy
C Start time
D Start slope time
3
E
Main current
F
Second energy
G Pulse frequency
H Pulse duty cycle (main current I
4
I
Crater fill slope time
J
Crater fill energy
K Crater fill time
L
Gas post-flow time
04.19
X
Secondary parameter description
I
II
III
IV
Standard value
0.1 s
50 %
0.1 s
0.5 s
100A
50 %
3.0 Hz
in %).
50 %
1
0.5 s
25 %
0.2 s
100 %
909.4169.9-03
shows in which segment of the secondary
parameters you currently are.
Starting, welding, crater filling, spot weld-
ing/interval
The inverted segment is shown in detail in
Area "II".
shows a detail overview of the inverted
segment in Area "I"
The parameter selected is represented by
a point.
shows the value of a selected parameter.
shows the calculated current and the mas-
ter reset value for the parameter selected.
Setting range
0.1 to 10 s
1 - 200 %
*
0 - 99.9 s
0 - 99.9 s
3 - 200 TIG
1 - 200 %
*
0.1 Hz - 5 kHz
1 - 99 %
0 - 99.9 s
1 - 200 %
*
0 - 99.9 s
20 - 500 %
1
Mode
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
- 41 -
Publicité
