05
Audio and Video Quality Settings
Video adjustments
1. Press the SETUP button to display the
SETUP menu, then select [Video Adjust]
and press the ENTER button.
Audio Settings
Play Mode
Initial Settings
2. Use the left/right cursor buttons (|, \)
to select from [Memory 1], [Memory 2],
or [Memory 3], then press the down
cursor button («); select [Detailed
Settings] and press the ENTER button.
Video Adjust
Memory 1
Detailed Settings
¶ If the ENTER button is not pressed before a certain
period of time has elapsed, the [Video Adjust] menu
screen will disappear and the selection will be canceled.
52
Video Adjust
Disc Navigator
3. Use the up/down cursor buttons (», «)
to select the item, then use the right/left
cursor buttons (|, \) to adjust or select
the value.
¶ See page 53 regarding the contents of setting items.
Memory 1
Recall Settings
Prog. Motion
first
PureCinema
YNR
off
CNR
off
Sharpness High
soft
Sharpness Mid
soft
Memory 1
Detail
off
White Level
min
Black Level
min
Black Setup
Gamma
Hue
green
Chroma Level
min
Memory 1
Chroma Delay
HDMI Color Adjust
DVI Detail
soft
¶ Pressing the DISPLAY button alternates between the
display of the single item selected and the full-screen
display.
4. After selecting/adjusting the necessary
items, press the ENTER button to exit the
menu.
¶ The video memory setting [Memory 1], [Memory 2],
[Memory 3] selected in step 2 will be stored.
¶ If the selected memory bank already has a video
memory setting stored in it, the previous contents will
be erased (overwritten).
Important
¶ After completing settings, be sure to press the EN-
TER button or SETUP button to confirm the selections.
If any other button is used to exit the setting menu,
the newly set contents will not be stored.
Note
¶ Some settings may not appear obvious, depending on
the disc or display used.
1/3
Memory 1
slow
Auto 1
max
max
fine
fine
2/3
max
max
max
0 IRE
–
+
red
max
3/3
–
+
Standard
fine