CAPITAL SPORTS Helix Stride Mode D'emploi page 67

Carefully insert the upper connection cable (66) into the handlebar (54).
Note: Make sure the following screws all attach, then fully tighten. Because
the handlebar screw holes are in very correct size, so making sure all
screws all put into before tightening.
Secure both sides of the handle (54) with
2 washers (74), lock washers (76) and
screws (96). Tighten the screws tightly.
Fasten the front of the handle (54) with
2 washers (74), lock washers (76) and
screws (96). Tighten the screws tightly.
EN
67