CAPITAL SPORTS Helix Stride Mode D'emploi page 59

EN
Then attach the rear
stabilizer to the main frame
with the washers (76), lock
washers (74) and screws
(105) just removed.
Step 4: Mounting the support tube
Place the main frame on
the polystyrene packaging.
Attach the support tube
(34) to the main frame using
washers (76), lock washers
(74) and screws (97). Do
not tighten the screws
completely at this stage!
Attach a washer (76),
lock washer (74) and
screw (97) to the bottom
of the support tube. Do
not tighten the screw
completely at this point!
Fix the support tube to
the rear stabilizer with a
washer (76), lock washer
(74) and screw (97).
59