CAPITAL SPORTS Helix Stride Mode D'emploi page 57

Step 2: Mounting the front stabilizer
The 4 Nymon nuts (87) were pre-installed
on the underside of the main frame (1).
Remove the nymon nuts (87).
Insert the lower adapter connecting wire (68) into the middle adapter connecting wire
(67). Be careful not to pinch the wires! Then insert the wires (67 & 68) neatly into the
hole of the snap-on socket (111).
Place the main frame (1) in the Styrofoam
packaging as shown. This makes it easier
to install the front stabilizer (32). Then
attach the front stabilizer (32) to the main
frame (1) with the wheels facing down
and tighten the 4 nylon nuts M10*1.5
(87). Be careful not to pinch the wires!
EN
57