Error Messages - AS Torantriebe CTR54 Manuel D'emploi

ENGLISH

3) Error messages

In case of anomalies or particular conditions, the display shows the following messages :
Message
The memory that contains the remote control codes is full.
FULL
50 codes have been inserted in the memory.
The STOP electric contact on the terminal board J1 (clamps 5 and 8) is open.
STOP
The STOP contact must be put in short-circuit if it's not used.
During the photocell test an error has been detected. Attention: verify the
T PH
operation of the photocell before starting the gate motion.
During the motion of the wing an obstacle has been detected. Attention: remove
OBST
the object that obstruct the correct movement of the wing.
The gate is in the Pause period before the closure in the logic of operation
PAUS
Automatic or Condominium.
OPEN It signals that the gate is in the opening phase.
CLOS It signals that the gate is in the closing phase.
It signals that the gate is in stop, despite a command of Start or Pedestrian
Start has been sent. The blinker signals with fixed light the anomalous condition.
PHOT
Attention: interrupt the working cycle and verify the operation of the Photocell
and the Photostop.
Description
43