Programs Menu - AS Torantriebe CTR54 Manuel D'emploi

ENGLISH
Setting the work time (only for a 2-wings gate) :
1 - Make sure the gate is completely closed. If not, position it manually.
2 - Press the P2 key until the writing "LRN" and successively the writing "TIME" appear on display (after 2 sec. approx.),
3 - release the P2 key, the gate will start opening at a reduced speed,
4 - during this phase adjust the trimmer RV1 to obtain the desired slow-down speed,
5 - when the gate is completely opened, press the P2 key again and wait for the blinker lighting with a fixed light (after 3 sec. approx.),
6 - adjust the RV1 trimmer to half of run and successively press the P2 key for 1 second to start the M1 motor,
7 - let the desired time pass (M2 wing closing delay) then press the P2 key for 1 second to start the M2 motor,
8 - when the shutter M1arrives to a distance of 50cm from the complete closing, press the P2 key for 1 sec. to start the motor M1 slowing down phase,
9 - when the shutter M2arrives to a distance of 50cm from the complete closing, press the P2 key for 1 sec. to start the motor M2 slowing down phase,
10 - 3 seconds after the complete closing of the shutter M1, press the P2 key for 1 second to stop the motor M1,
11 - 3 seconds after the complete closing of the shutter M2, press the P2 key for 1 second to stop the motor M2, end.
Note : during the work times programming all the safety devices are ignored.
Warning : during the programming, if the device detects that no Encoder is connected to the motor, it will disable automatically the control of the same
one. The check is separately effected for each motor.

2) Programs menu

Attention: the selection of the logic of operation and the times setting must be carried out only if the working cycle is finished or before it starts
(closed gate).
The Programs menu has a stepped structure composed by three levels:
In the Programs menu the keys act in the following way:
P1 - Confirmation key / Exit key

It allows the access from Menu to Undermenu

It allows the access from Undermenu to Selection

In the Selection it acts as confirmation key and back to the Undermenu

ESC confirmation in a Undermenu allows the return to the Menu

ESC confirmation in a Menu allows the exit from the programming
P2 - Scrolling key

In a Menu or Undermenu It allows to jump from an item to the following

In the Selection It allows to jump from an item to the following (choice of a logic of operation)

In the Selection It acts as increment key (time or data setting)
MENU UNDERMENU
39
SELECTION