Power Supply - AS Torantriebe CTR54 Manuel D'emploi

ENGLISH
3) Definitions of Outputs
Blinker
Lamp's on/off control. The lamp functions as a warning and optical signaller of potential danger for the gate's motion.
Motor 1
Outputs for the opening/closure control of the motor which drives the first gate wing during the closing phase.
Motor 2
Outputs for the opening/closure control of the motor which drives the gate wing delayed during the closing phase. This wing is usually connected with
an electric lock.
Electric lock
Impulse control for the electric lock release.
Courtesy light
Continuous control for the lamp which lights the area around the gate. The lamp is lit for approx. 2 minutes after the cycle has ended. During the pause
before the gate closes back the lamp is lit.
Open gate lamp
Continuous control for the lamp that signals the gate's position. La lamp goes off only after the gate has completely closed.
Photocells test
It's an output controlled by Microprocessor for the Photocell power supply. It allows to check the Photocell working before the motors departure.
4) Definitions of Power Supply Inputs/Outputs
230 Vac mains power
Input for the electronic board power supply.
24 Vac low voltage
Power supply output for the photocell, photostop and/or any other accessory devices.
5) Definitions of Accessory Inputs/Outputs
Aerial
Input for the connection of a radio receiving aerial. This input can only be used if a radio receiver card is connected to the unit.
Encoder
Logic input that allows the microprocessor to detect the shutter speed and to define its exact position during the run. If the motor is endowed with
incremental encoder , it is possible to establish with precision the point of beginning of the slowing down and the position of the shutter end-run.
27