Card Programming; Primary Setting - AS Torantriebe CTR54 Manuel D'emploi

ENGLISH
G) Card programming

1) Primary setting

After the power is supplied to the electronic card, proceed in the following way:
Remote control codes self-learning :
1 - Press the P1 key until the writing "LRN" appears on display,
2 - release the P1 key, on display will appear the writing "rCH1",
3 - Press the desired key on the remote control within 10 seconds to insert a Start code or press again P1,
4 - release the P1 key, on display will appear the writing "rCH2",
5 - Press the desired key on the remote control within 10 seconds to insert a Pedestrian Start code or press again P1,
6 - release the P1 key, on display will appear the writing "rCH3",
7 - Press the desired key on the remote control within 10 seconds to insert a Courtesy light switch on command or press again P1 to return to the
Point 1.
Erasing all stored codes :
dEL.C
1 - Press the P1 key until the writing " " appears on display (after 10 sec. approx.),
2 - release the P1 key, end.
Setting the pause time :
1 - Press the P3 key until the writing "LRN" and successively the writing "PAUSE" appear on display (after 2 sec. approx.),
2 - release the P3 key and let the desired Pause time pass (the display shows the seconds counting),
3 - then press the P3 key for 1 second, end.
Warning : the electronic card is predisposed to a 2-wings gate connection. If the card has been connected to a single-wing gate, before proceeding to
the work times programming, enter in the programs menu and load the default value DEF1 (go to page 42).
Setting the work time (only for a single-wing gate) :
1 - Make sure the gate is completely closed. If not, position it manually.
2 - Press the P2 key until the writing "LRN" and successively the writing "TIME" appear on display (after 2 sec. approx.),
3 - release the P2 key, the gate will start opening at a reduced speed,
4 - during this phase adjust the trimmer RV1 to obtain the desired slow-down speed,
5 - when the gate is completely opened, press the P2 key again and wait for the blinker lighting with a fixed light (after 3 sec. approx.),
6 - adjust the RV1 trimmer to half of run and successively press the P2 key for 1 second to start the M1 motor,
7 - when the shutter M1arrives to a distance of 50cm from the complete closing, press the P2 key for 1 sec. to start the motor M1 slowing down phase,
8 - 3 seconds after the complete closing of the shutter M1, press the P2 key for 1 second to stop the motor M1, end.
Note : during the work times programming all the safety devices are ignored.
38