Electric Connections - AS Torantriebe CTR54 Manuel D'emploi

ENGLISH

14) Electric connections

9 electric connectors are fitted to the card :
a) J2 8-pole Terminal board for the connection of the devices operating with 230Vac mains power supply (motors and blinker)
b) J1 10-pole Terminal board for the connection of the devices operating at low voltage (commands, safety devices, electric lock and 24Vac power
supply output)
c) J8 2-pole Terminal board for the connection of the courtesy light
d) J9 2-pole Terminal board for the connection of open gate lamp or other auxiliary device
e) J5 2-pole Terminal board for the connection of the aerial cable
f) J7 3-pole Terminal board for the connection of the mains power supply and the ground cable
g) J6 10-pole connector for the optional connection of a radio receiver card
h) J3 8-pole Terminal board for the connection of the limit switches and/or Encoder
i) J10 6-pole connector for the joint of the power supply transformer
Terminal board J7
Terminal 1 – Ground cable connection
Terminal 2 - 230Vac mains power supply phase
Terminal 3 - 230Vac mains power supply neutral
Terminal board J2
Terminal 1 - 230Vac motor M1 power supply phase (opening)
Terminal 2 - 230Vac motor M1 power supply phase (closure)
Terminal 3 - 230Vac motor M1 Power supply common
Note: connect the capacitor of the motor M1 between terminals 2 and 1
Terminal 4 - 230Vac motor M2 power supply phase (opening)
Terminal 5 - 230Vac motor M2 power supply phase (closure)
Terminal 6 - 230Vac motor M2 Power supply common
Note: connect the capacitor of the motor M2 between terminals 4 and 5
Terminal 7 - 230Vac blinker power supply phase
Terminal 8 - 230Vac blinker power supply neutral
33