AS Torantriebe CTR54 Manuel D'emploi page 40

P3 - Scrolling key

In a Menu or Undermenu It allows to jump from an item to the previous

In the Selection It allows to jump from an item to the previous (choice of a logic of operation)

In the Selection It acts as decrement key (time or data setting)
Press the P3 key for 5 seconds to access to the main menu, on the display the writing "SET" will appear. You can find the whole structure table of the
Programs menu as follows:
Menu Undermenu Selection
MODE
N.MOT
BEZY
SET
DEL.0
CL.IM
BL.IN
M.AUS
SPEd
ESC
SbYS It allows to select the logic of operation of the gate (see pag. 31). There are three different logics
Auto of operation: Step by Step (SbYS), Automatic (Auto) and Condominium (Cond).
Cond
1MOT It predisposes the device for the operation with 1 or 2 motors. Selecting 1MOT the operation with
2MOT the logic "single wing" will be enabled (see pag. 31).
oFF Selecting on, the "kickback" procedure will be enabled (see pag. 30).
on
oFF Selecting on, all the delays between the two shutters of the gate will be erased (closing and
on opening).
oFF Selecting on, in opening or during the pause period, after the photocell is crossed, it causes the
on gate's stop and immediate closure after approx.1 second.
oFF Selecting oFF, the electronic card will supply a continuous 230Vac voltage to the
on Blinker (flashing light off).
OP.Lt It establishes if the output AUX on the terminal board J9 must operate as Open gate lam (OP.Lt)
tESt or Photocell test (tESt)
1 - 4 It allows to program the slow-down speed of the shutter. The minimum speed corresponds to the
value 1.
Return to SET menu
Description
(see pag. 27).
40
ENGLISH
Default
SbYS
2MOT
oFF
oFF
oFF
on
OP.Lt
1