Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
In standard configurations (for example CBL00-Encl.3/A) it is not possible to
connect more than one motor in parallel to the same speed selector or ther-
moregulator. For this requirement, a special optional card and the relevant elec-
tric diagram are necessary.
Each fan coil is provided with:
•
screw terminal board for the electrical connections, indicated inside the CBL00 control
box (s. Enclosure 4 - Fig. 1);
•
electric wiring diagram, specific for the working of the unit and its accessories, located
in the front inner part of the unit;
•
ground protection terminal marked with the symbol
ground protection system cable (yellow/green).
To connect the fan coil unit to the electric system, operate as follows:
1.
Insert the wires (factory pre-wired cable) through
the slots in the base of the control box (see en-
closure 1/A, 1/B, 1/C pos. 7) and make the elec-
trical connections accordingly to the electric wir-
ing diagram located in the front inner part of the
unit and to the diagram of the controller.
2.
Fix the wires to the base of the control panel by
using the given cable clamps and be sure that the
wires under the panel with the slots are blocked
at a distance of at least 5 mm from the slots
themselves.
3.
Fix back the cover box to the base with the screw.
4.
Pay attention to the fixing and the path of the
connection cables, as illustrated in fig. 7.
5.
Make sure that the installation doesn't damage
the components and cannot be of any danger to
persons, objects or animals.
ALWAYS GROUND THE UNIT.
for the connection of the
EN
1
2
3
4
5
6
7
8
9
10
+
Fig. 7
35
Publicité
Table des Matières
