Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig. 6a
Note: before inserting the drain pan, drill the internal plastic cap of the tray
with drill bit diameter 10 mm.
•
Horizontal models, insert the pipe of the drain pan into the hole in the side of the unit;
then fix it with the two supplied screws (Fig. 6a). ONCE FIXED THE DRAIN PAN SEAL THE
LOWER PROFILE WITH SILICONE.
•
Insert manually the elbow for condensate discharge,
without using any tool and connect it to the small pipe of
the main condensate tray.
In case of operation of the unit in «cooling» mode,
Eurapo recommends to operate as follows:
•
install an electric valve (optional supplied on request),
which stops the cold water flow inside the heat exchanger when the unit is inoperative;
•
foresee a suitable water condensate drainage system, duly slanting, and
check the proper downflow;
•
execute a proper insulation of valves, pipes and connection fittings of the fancoil to
the system.
IT IS RECOMMENDED TO SIPHON THE CONDENSATE DRAIN
•
EN
1
2
3
4
5
6
7
8
9
10
+
33
Publicité
Table des Matières
