Quickie SOPUR P-220 Manuel D'utilisation Et Garantie page 24

24
N. LIGHT UNIT
If your wheelchair is equipped with a light unit, when you are disassembling the wheel-
chair, you must also undo the plug connection to the light module, in order to disconnect
the frame from the drive unit. The light circuit is protected with blowout fuses, which are
located under the seat, along the light cable harness. Should a fuse (1A T) blow, then you
can replace it with a standard fuse of the same rating.
When in doubt, please contact your Sunrise Medical supplier.
MANUAL WHEELCHAIR CONVERSION KIT
A. JOYSTICK
Removal
a. Disconnect the joystick by pulling back on the retaining collar (A).
b. Remove joystick power cable from armrest.
c. Remove joystick assembly.
B. POWER DRIVE UNIT
Detachment
a. Release both quick-connect levers (B) until completely disengaged.
b. Lift seat and main frame off power unit.
c. Set power unit aside.
C. WHEEL LOCKS
Wheel locks are installed by Sunrise Medical when requested on the Quickie/Sopur P-220.
Adjustment
The wheel locks mount on a split clamp system. Use a torque of 100 in./lbs. (11.3 Nm)
when adjusting the position of the wheel locks.
1. Loosen the screws on the side of each clamp (C) using a 3/16" Allen wrench. Do not
attempt to remove one screw at a time.
2. Slide assembly toward rear wheel until clamp embeds into tyre to prevent wheel
movement when in the locked position.
3. Adjust angle position. Tighten screws.
D. 24" (600mm) REAR WHEELS
Installation
1. Depress the quick-release button (A) on the axle.
2. Slide it into the axle sleeve until it locks.
E. ANTI-TIP TUBES
Sunrise Medical recommends anti-tip tubes for all wheelchairs.
NOTE– Use a torque setting of 100 in.-lbs (11.3 Nm) when setting-up anti-tip receivers.
1. Inserting anti-tip tubes into receiver
a. Press the rear anti-tip release lever on the anti-tip tube so that both release pins are
drawn inside.
b. Insert into the anti-tip tube receiver on the axle tube assembly.
c. Turn the anti-tip tube down until release pin is through the receiver.
d. Insert second anti-tip tube the same way.
2. Turning anti-tip tubes up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing
kerbs.
a. Press the rear anti-tip tube release lever.
b. Hold lever in and turn anti-tip tube up.
c. Release lever.
d. Repeat with second anti-tip tube.
e. Remember to return anti-tip tubes to down position after completing manoeuvre.
930479 Rev. C
All manuals and user guides at all-guides.com
E n g l i s h
I X . S e t - u p , A d j u s t m e n t s a n d U s e
A
A
B
A