Quickie SOPUR P-220 Manuel D'utilisation Et Garantie page 22

22
E. ELEVATING LEGREST (OPTIONAL)
1. Installation
To install or remove Elevating Legrest (ELR) see instructions for swing-away footrest instal-
lation.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, first lift slightly then press release lever (G)
down and lower legrest to desired position.
F. JOYSTICK INSTALLATION
1. To connect
a. Line up small cylindrical connector with its receptacle on the rear of the joystick.
b. Push in firmly.
2. To disconnect
Pull back on the retaining ring (H) of the cylindrical connector until it disconnects from
the joystick box.
G. TO ADJUST THE HEIGHT OF THE REMOTE JOYSTICK
a. Remove the two pan-head screws (A), securing the angle bracket mount (B).
b. Remove the joystick from the mount by unfastening the two screws (C) on the under-
side of the mount.
c. Position angle bracket mount such that you achieve the desired joystick height. Four
positions are available by relocating the mount either on the top or bottom of the
mounting bar (D) and/or by rotation of the angle bracket mount.
H. REMOTE JOYSTICK SWING-AWAY RETRACTABLE MOUNT (OPTIONAL)
The remote joystick is mounted with a mechanism which allows the control to be locked in
a forward or retracted position.
Adjustment
a. To retract joystick, depress lever (E) located on the side of the armrest.
b. Push joystick away from front of armrest until it locks into retracted position.
c. To return to forward position, depress lever and push joystick forward until it locks
into place.
I. DUAL-POST HEIGHT-ADJUSTABLE ARMRESTS
The dual-post flip-back armrest can be used as either a flip-back armrest or a removable
armrest.
1. Installing armrest
a. Insert front and rear posts into armrest receivers.
b. Tighten clamp levers (A) and (B) to secure armrest.
2. Set-up for flip-back operation
a. Loosen clamp lever (A) so front post is able to come free.
b. Armrest now has the ability to be flipped back without removal.
3. Set-up for removal
a. Insert front and rear posts into armrest receivers.
b. Loosen clamp lever (A) and (B) so front and rear post are able to come free.
c. Armrest can now be easily removed for transferring.
4. Height-Adjustment (option)
a. Release the upper securing lever (C).
b. Set at desired height.
c. Return securing lever to locked position.
d. Move armrest up or down to allow armrest to snap into place.
930479 Rev. C
All manuals and user guides at all-guides.com
E n g l i s h
I X . S e t - u p , A d j u s t m e n t s a n d U s e
B
C
G
H
H
A
D
E
C
B
A