Videotec ULISSE2 Manuel D'instructions page 45

10.3.12 Preset Page
From menu entry Preset a number of parameters
relative to the presets can be configured:
• Scan Speed: The speed, measured in degrees to
the second, at which a preset is reached by explicit
operator request.
• Speed of Movements Default: The speed used in
autopan and patrol operations.
• Impose Default Speed: The default speed will also
be set as the scanning speed for all presets.
• Default Dwell Time: The amount of time, in
seconds, it stays in each preset by default.
• Impose Default Pause: The default pause will be
set for all presets.
Fig. 82
10.3.13 Preset (Advanced) Page
In the Preset (Advanced) section it is possible to
customise the speed and pause values for each
preset, in addition to enabling/disabling the presets
themselves.
The speed and pause values are used for Patrol
management.
Fig. 83
MNVCU2_2222_EN
10.3.14 Digital Inputs Page
The Digital Inputs menu allows you to configure the
digital channels on the device. What follows is a brief
description of the configurable parameters for each
digital input.
• Alarm ID: Field used to select the desired digital
input. The alarm input 5 is found in the housing.
For connection refer to the chapter (AL, COM, 7.4.3
Network camera connection, page 18).
• Input Description: Enter a text description of the
input functionality.
• Type: It indicates the default state of the digital
input.
• Action: Each input can be associated with an
action. The action is activated when the contact is
in a state other than default. The available actions
are listed below:
• NONE: No action.
• SCAN: Position the pan & tilt on the selected
preset.
• PATROL: Activate the PATROL.
• AUTOPAN: Activate AUTOPAN.
• WIPER: Enables the wiper.
• WASHER: Activate the glass cleaning sequence.
• DNHOUSING: Enable the relay in the housing.
For connection refer to the chapter(DN1, DN2,
7.4.3 Network camera connection, page 18).
• RL1: Activate Relay 1.
• RL2: Activate Relay 2.
• IR FILT: Deactivate the camera's IR Filter. If
available, it turns on the LED illuminators.
43