Videotec ULISSE2 Manuel D'instructions page 18

Align the lens edge with the edge of the slider.
Fig. 14
Once the edges are aligned, without moving the
camera and lens unit, move the camera slider in line
with one of the 3 slots on the main slider.
Fig. 15
On reaching the optimum position, remove the main
slide (taking care not to lose the position) and fasten
in place using the 1/4" screw.
Fig. 16
16
Re-position the main slider on the camera/lens/slider
unit. Align the camera slider hole with the previously
selected main slider slot (01). Partially screw in the
camera slider screws (screws and washers supplied).
For optimum hold use the flat and lock washers.
Tighten the 1/4" lens screw (02).
01
Fig. 17
Fully screw in the camera slider screws.
Fig. 18
Pay attention to the fixing. Tightening
torque: 2.1Nm.
02
MNVCU2_2222_EN