Videotec ULISSE2 Manuel D'instructions page 24

Open the hatch by undoing the screws as shown in
figure.
Insert the cables into the cable glands holding the
base at about 20cm from the support.
Power supply (01)
Digital I/O (02)
Fig. 32
Use power cables (01) and Ethernet network cables
(03) with a diameter of between 5mm and 13mm. If
the Ethernet cable is already fitted with a connector,
it is necessary to use the special seal provided.
Fig. 33
Pay attention to the fixing. Tightening
torque: 2.7Nm.
Use a digital I/O cable (02) with a diameter of
between 5mm and 10mm (for diameters between
3mm and 7mm use the special seal).
Pay attention to the fixing. Tightening
torque: 2Nm.
22
Ethernet (03)
Once you have positioned the gasket (01), fix the
base (02) onto the bracket (03) with screws (04),
serrated washers (05) and screw rings (06).
02
01
06
Fig. 34
Use the screws and washers provided with
the support.
Put some thread-locker into the holes for
screws (Loctite 243®).
Pay attention to the fixing. Tightening
torque: 6Nm.
02
01
06
03
05
04
03
05
04
MNVCU2_2222_EN