Fitting The Bracket - Videotec ULISSE2 Manuel D'instructions

8.6 Fixing the upper body
Place the unit body on the base aligning the
reference marks. Insert the unit body anti-tipping
columns in the holes on the base. Be especially
careful not to damage internal components during
installation.
Fig. 43
Fasten the upper body to the base using the fixing
screws. Check that a base gasket is present and in
good condition.
Fig. 44
Pay attention to the fixing. Tightening
torque: 6Nm.
28
8.7 LED illuminators installation
(optional features)
To work properly both illuminators must be
installed together.
From Pan & Tilt, it is only possible to install
VIDEOTEC illuminators.

8.7.1 Fitting the bracket

Position the bracket (01) on the bottom of the
housing as shown in figure. Install the screws and the
washers (02) in the holes (03) and tighten them.
03
01
02
Fig. 45
Pay attention to the fixing. Tightening
torque: 6Nm.
03
MNVCU2_2222_EN