Videotec ULISSE2 Manuel D'instructions page 21

7.4.4 Connecting the controlled
motorised lenses when powered
All configuration options must be set in the relevant
chapter (10.3.2 Hardware Configuration Page, page
34).
7.4.4.1 Connecting the lenses with reverse
polarity motors
If the lens motors have reverse polarity, use the
following connection diagram.
+
M
+
M
Fig. 22
7.4.4.2 Connecting lenses with common
wiring motors
If the lens motors are the common wiring type, use
the following connection diagram.
+
M
+
M
Fig. 23
MNVCU2_2222_EN
FOCUS +
FOCUS -
ZOOM +
ZOOM -
AF1
AF2
J7
FOCUS +
FOCUS -
ZOOM +
ZOOM -
AF1
AF2
J7
7.4.4.3 Adjustment of the supply voltage of
the lens motors
Before switching the Pan & Tilt on, select the lens
power supply voltage using the lens voltage DIP
switches (DIP2, 7.4.1 Housing board description,
page 17).
ADJUSTMENT OF THE SUPPLY VOLTAGE OF THE LENS MOTORS
SW1 SW2 Voltage
OFF OFF 15Vdc
ON OFF 12Vdc
OFF ON 9Vdc
ON ON 6Vdc
Tab. 3
7.4.4.4 Connecting the potentiometers
Make the connections as shown in figure.
Fig. 24
+V_POT
FOCUS
ZOOM
-V_POT
J6
19