Connector Board Description; Connection Of The Power Supply Line - Videotec ULISSE2 Manuel D'instructions

8.2 Connecting the Pan & Tilt to
the system

8.2.1 Connector board description

BOARD DESCRIPTION
Components Function
J1 Power supply line
J2 Ethernet
J3 Digital I/O
DIP1 Selecting Master mode, restoring factory
default settings
F1 Power line fuse
F2 Pan & Tilt electronic power supply fuse
F3 Illuminator power supply fuse
LD1, LD3 Ethernet line status (link and activity)
LD2 Firmware status
LD4, LD5 Status of the communication line with the
camera (link and activity)
LD6 Power status
Tab. 4
J1 LD1
F1 LD6 F2
Fig. 35
MNVCU2_2222_EN
J2 LD3 DIP1 LD5 LD4
F3 J3 LD2
8.2.2 Connection of the power supply
line
Depending on the version, the device can be
provided with different power supply voltages. The
power supply voltage is indicated on the product
identification label. (4.3 Product marking, page 11).
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Check that the power supply socket and
cable are adequately dimensioned.
Earth cable should be about 10mm longer
than the other two, so that it will not be
disconnected accidentally if pulled.
Cut the cables to the correct length and make the
connections. Connect the power supply to the
connector.
The power supply cable must be covered by the
silicone sheath (01) supplied. The silicone sheath
must be fastened with the corresponding cable tie
(02).
01
N
a
L
Fig. 36
02
23