Videotec ULISSE2 Manuel D'instructions page 42

10.3.4 Device Parameters Page
From menu entry Device Parameters it is possible to
set the name of the device and view other additional
information.
Fig. 74
10.3.5 Device Statistics page
From menu entry Device Statistics all of the statistics
are gathered during device operation are provided in
read-only mode.
Fig. 75
40
10.3.6 Network Page
In order for the device to operate correctly,
it is necessary to synchronise it with the
VMS software using a NTP server.
From menu entry Network it is possible to change
the setting of the Pan & Tilt network. It is possible
to decide whether the device requires an address
assigned statically, dynamically with DHCP or self-
generated. The device supports the Internet Protocol
(IP) in version 4.
From the same page it is possible to configure 2 DNS
and decide which mechanisms must be enabled
to automatically identify the devices in the local
network.
NTP Server: It is also possible to specify if the device
needs to be synchronised with an external NTP
(Network Time Protocol) server.
• DISABLED: Select this option if you do not wish to
synchronise date and time of the device.
• DHCP: Select this option if you wish to synchronise
the date and time of the device with those of an
NTP server (Network Time Protocol) indicated by
the DHCP server.
• STATIC: Select this option if you wish to
synchronise date and time of the device with
those of the NTP (Network Time Protocol) server
specified by the static address.
PC Sync: This allows you to synchronise the date and
time of the product with that of the PC that you are
using (you need to re-execute the command after
each unit switch on-off cycle).
Fig. 76
MNVCU2_2222_EN