Videotec ULISSE2 Manuel D'instructions page 32

8.8 Connection of the LED
illuminators
Open the housing as described in the relative chapter
(7.3.1 How to open the housing, page 14).
Insert the power supply cables through the cable
glands by at least 10 cm. Tighten the cable glands.
Fig. 48
To ensure the safety and the correct
operation of the unit do not leave a surplus
of the cable externally.
Pay attention to the fixing. Tightening
torque: 2Nm.
There are two connectors on the housing card used
to control the illuminators (J11, J15, 7.4.1 Housing
board description, page 17).
Connect the cables as described in the table.
CONNECTION OF THE LED ILLUMINATORS
Master illuminator (J15)
Reference on Cable color
the board
PW2 White
PW1 Black
A Green
B Red
Tab. 9
Close the housing as described in the relevant
chapter (7.4.8 Closing the housing, page 21).
30
Slave illuminator (J11)
Reference on Cable color
the board
PW2 White
PW1 Black
A Green
B Red
8.9 LED illuminator activation
and adjustment instructions
Once the adjustment has been completed, the
Master illuminator will synchronise and control the
Slave illuminator.
Master
Fig. 49
The dusk switch detects the room light and controls
the activation and deactivation of the illuminators
when brightness reaches the level set by the user.
When the LED illuminators are active the camera
goes to night mode with the special ONVIF control.
If the camera does not manage the ONVIF command
to switch to night mode, synchronisation can still
be performed via the relative relay (DN1, DN2, 7.4.3
Network camera connection, page 18).
Slave
MNVCU2_2222_EN