Installing The Memory Card - Videotec ULISSE2 Manuel D'instructions

8.3.2 Description of the Factory Default
procedure
If the access password is no longer available, follow
the procedure to reset to default factory settings.
• Switch off the unit.
• Open the connector housing cover.
• Locate the DIP-switch 1. Turn switch 2 ON.
• Close the connector housing cover.
• Power the unit.
• Wait 60 seconds.
• Switch off the unit.
• Open the connector housing cover.
• Turn switch 2 OFF.
• Close the connector housing cover.
• Power the unit.
If the camera installed is a third party brand, you
will need also to run the Factory Default procedure
specified by the camera manufacturer.
8.4 Closing the connector
housing cover
Replace the connector cover being careful not to
crush the cables when closing.
Fig. 41
Pay attention to the fixing. Tightening
torque: 6Nm.
MNVCU2_2222_EN

8.5 Installing the memory card

It is possible to equip the unit with a micro SD
memory card. The memory card can be used to
backup all the configurations and system logs
for easier maintenance or replacement in case of
malfunction. For further information refer to the
relative chapter (10.3.22 Tools Page, page 50).
Fig. 42
The system is able to handle micro SDs of up to 4GB.
Tested memory cards:
• Panasonic RP-SMKC04DE1 (4GB, -40/+85°C)
• Swissbit SFSD2048N1BW1MT-I-ME-111-STD (2GB,
-40/+85°C)
27