Assembling And Installing; Assembly; Camera's Required Features For Installation - Videotec ULISSE NETCAM Manuel D'instructions

7 Assembling and installing

The assembly and installation must be
performed only by skilled personnel.
This is a Class A product. In a domestic
environment this product may cause radio
interference. In this case the user may be
required to take adequate measures.
Only network cameras with specific
technical characteristics can be installed
(7.1.1 Camera's required features for
installation, page 14).
14

7.1 Assembly

7.1.1 Camera's required features for
installation
• Only cameras with a 100 baseTx type ethernet
communication port can be mounted.
• Only cameras powered by a terminal can be
mounted as the Pan & Tilt cannot supply power
directly on the ethernet cable (power over
ethernet).
• The power supply voltage of the camera must be
12Vdc.
• The maximum absorbed current by the camera
must be less than 800mA.
• The communication protocol must be ONVIF,
S profile, protocol. The camera must be pre-
configured in order to communicate via the ONVIF,
S profile, protocol.
• The operation temperature range of the camera
must be between -10/+60°C.
• The camera must be pre-configured in order to
acquire the IP address via DHCP.