Housing Board Description; Connection Of The Camera And Motorised Lens - Videotec ULISSE2 Manuel D'instructions

Place the camera in the housing and fasten in place
using the screws and washers.
Fig. 19
Pay attention to the fixing. Tightening
torque: 2.1Nm.
7.4 Connection of the camera and
motorised lens
Before making the connections make sure
that the voltages supplied by the board fall
within the limits allowed for the apparatus.
The electronics board is designed to control cameras
with motorised lenses, which may or may not have
potentiometers to control the position reached.
MNVCU2_2222_EN

7.4.1 Housing board description

BOARD DESCRIPTION
Compo- Function
nent
J4 Not used
J5 RS-485 (lens)
J6 Reading the lens potentiometers
J7 Lens motor power supply, One Push AF
J8 Lens motor power supply, One Push AF, reading the
lens potentiometers
J9 Visible cut filter
J10 Power supply and control (integrated camera)
J11 Power supply and control (Slave illuminator)
J12 Board diagnostics
J13 RS-485 (camera)
J14 Camera power supply, camera input alarm, camera
output alarm
J15 Power supply and control (Master illuminator)
J16 Heated glass
J17 Wiper
J18 Ethernet
DIP2 Lens voltage
DIP3 Housing configuration
LD7 Internal power supply status (5V)
LD8 Internal power supply status (3,3V)
LD9 Firmware status
LD10 Camera power status
LD11 Internal power supply status (12V)
LD12 PoE power supply status
Tab. 1
17