Housing Board Description; How To Install The Camera; Connection Of The Camera - Videotec MAXIMUS MMX Manuel D'instructions

7.5 Housing board description

BOARD DESCRIPTION
Connector/ Function
Terminal
J1 Power supply line (24Vac/24Vdc)
J4 Heater
J5 Board test
J6 Blower
J7 Connection to the video encoder
J8 Ethernet, PoE+ power supply
F1 Fuse
SW1 Reset dip-switch
Tab. 8
F1 J1 J8
Fig. 21
MNVCMMX_1821_EN

7.6 How to install the camera

To install the camera (01) you need to remove the fan
(02).
J6 J4
J5 J7 SW1
Fig. 22

7.7 Connection of the camera

Connect the camera using a microcoaxial cable with
a USLS-30 connector on the video encoder interface
board (J2, 7.4 Description of the retrofit board for a
video encoder, page 18).
The cameras to be installed shall not
contain cells or batteries.
For additional information on installable
cameras, refer to the relative chapter (3.1.2
Characteristics of installable cameras, page
8).
02
01
19