Troubleshooting - Ariens Sno-Tek 24E Manuel Du Propriétaire

All manuals and user guides at all-guides.com
PROBLEM PROBABLE CAUSE
Engine will
1. Fuel tank is empty.
not
crank/start.
2. Fuel shut-off valve
3. Build up of dirt and
4. Key switch not in run
5. Engine start switch turned
6. Electric starter not
Engine stops.
1. Out of fuel.
2. Fuel shut-off valve
3. Mechanical jam in auger
4. Contaminated fuel supply.
5. Faulty spark plug.
6. Plugged fuel cap vent.
Engine 1. See Engine Manual.
problems.
Does not
1. Friction disc worn out.
operate in
Forward /
2. Traction belt not
Reverse.
3. Speed selector not
Small rubber
1. Friction disc wear.
beads collect
in frame

TROUBLESHOOTING

closed.
residue around
governor/carburetor.
position.
off.
functioning
closed.
or impeller.
functioning.
adjusted properly.
GB - 33
CORRECTION
1. Fill fuel tank. DO NOT
OVERFILL! (see Filling Fuel
Tank on page 18).
2. Open fuel shut-off valve.
3. Clean area around
governor/carburetor.
4. Put Key switch into run
position.
5. Turn switch on. See Starting
and Shut Off on page 19.
6. Check for bad starter
connections.
1. Fill fuel tank. DO NOT
OVERFILL! (see Filling Fuel
Tank on page 18).
2. Open fuel shut-off valve.
3. Turn off engine, remove key,
and wait for all moving parts to
stop. Check for and remove
obstruction and repair before
restart.
4. Replace with clean fuel.
5. Replace or clean spark plug.
6. Replace fuel cap.
1. See Engine Manual.
1. Replace friction disc (see
Friction Disc Replacement on
page 30).
2. Repair or replace traction drive
belt (see Traction Drive Belt
Replacement on page 29).
3. Adjust speed selector (see
Speed Selector Adjustment on
page 25).
1. Normal friction disc wear.
Chunks or large pieces of
rubber mean friction disc
should be checked and
replaced as necessary.