Ariens Sno-Tek 24E Manuel Du Propriétaire page 10

ASSEMBLY
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
• Torque Wrench (Optional)
Unfold Lower Handlebar
(Figure 4)
1. Remove wheel pins from each side of
the unit and slide wheels away from
frame (Figure 4). Do not remove wheels
completely.
IMPORTANT: Be sure to block wheels or
secure unit so it does not move during
assembly.
.
1
4
2
3
1. Lower Handlebar
2. Wheel Pin
3. Wheel
4. Mounting Hole
Figure 4
2. Rotate lower handlebar out from unit so
lower handlebar mounting holes align
with mounting holes on the unit frame.
3. Secure lower handlebar to unit using two
3/8 in x 3/4 in. hex head serrated flange
grade 5 bolts (Figure 3, Item 12).
4. Tighten all four bolts to 25 – 42 lbf-ft
(33.9 – 56.9 N•m).
5. Slide both wheels back into place and
reinstall wheel pins (Figure 15).
All manuals and user guides at all-guides.com
Attach Upper Handlebar Assembly
(Figures 5 and 6)
IMPORTANT: DO NOT tighten hardware.
Allow upper handlebar assembly to hang
from the lower handlebars for the next step
(Figure 5).
.
.
GB - 10
1. Attach upper handlebar assembly to
lower handlebar using two sets of the
handlebar hardware. One set to attach
each side of the handlebars (Figure 5).
7 6
1. Upper Handlebar Assembly
2. Lower Handlebar
3. 5/16 in x 2-1/4 in. Round Head
Square Neck Grade 5 Bolt
4. Handlebar Spacer
5. Flat Steel Washer
6. Locking Washer
7. 5/16 in Nyloc Nut
Figure 5
2. Hook spring end of attachment control
cable to the clutch arm (Figure 6).
3. Hook spring end of the traction control
cable to the cable eyelet on back of
frame (Figure 6).
4
2
1. Clutch Arm
2. Cable Eyelet
3. Attachment Control Cable
4. Traction Control Cable
Figure 6
5
4
2
3
1
3
1