Maintenance; Maintenance Schedule - Ariens Sno-Tek 24E Manuel Du Propriétaire

Ariens dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
(Figure 16)
WARNING: Before tipping unit up onto
housing, close fuel shut-off valve, and
drain fuel tank and fuel system so no
spills will occur (see engine manual for
complete instructions). Ensure unit is
secure and will not tip over during

maintenance.

Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
Service Position
Figure 16
All manuals and user guides at all-guides.com
MAINTENANCE

MAINTENANCE SCHEDULE

The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction drive
clutch lever is released, then both clutches
must disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
GB - 21
MAINTENANCE SCHEDULE
Service Each Every
Performed Use 5 hrs.
Check Dual •
Handle
Interlock
Check •
Fasteners
Check Clutch •
Operation
Check Clutch
Cable
Adjustments
Clean Engine •
Check Engine
Oil
Change
Engine Oil**
Check Tire
Pressure
Check Auger
Gearcase
General
Lubrication
*
After first 5 hours of operation.
**
Refer to Engine Manual for detailed
instructions.
Every Yearly
25 hrs.
* •
•
•
• •
• •