Ariens Sno-Tek 24E Manuel Du Propriétaire page 11

Unfold Upper Handlebar Assembly
(Figure 7)
1. Rotate the handlebar into operating
position.
NOTE: Be careful not to damage cable spring
hooks when rotating handlebar upward.
.
1
5
2
1. Shift Rod
2. Handlebar Hardware
3. Shift Rod Hardware
4. Upper Handlebar Assembly
5. Lower Handlebar
Figure 7
2. Install the remaining handlebar
hardware attaching the upper handlebar
assembly to the lower handlebar
(Figure 5).
3. Tighten all hardware.
4. Remove packaging around shift rod.
5. Rotate shift rod into place and tighten
hardware.
6. Connect shift rod to speed selector arm
and adjust as specified in Speed
Selector Adjustment on page 25.
7. Adjust attachment control cable as
specified in Attachment Clutch/Brake
Adjustment on page 26.
8. Adjust traction control cable as specified
in Traction Drive Clutch Adjustment on
page 28
All manuals and user guides at all-guides.com
Install Discharge Chute and
Discharge Chute Crank
(Figures 8 and 9)
NOTE: Leave discharge chute pedestal loose
to help install the chute crank.
3
4
NOTE: Be careful not to damage nylon
bushing when attaching crank to the control
panel.
GB - 11
1. Remove mounting hardware from the
auger housing.
2. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 1.
2
3
1
5
1. Mounting Holes
2. Discharge Chute
3. Discharge Chute Ring
4. Chute Pedestal
5. Mounting Hardware
Figure 8
3. Slide chute crank through the nylon
bushing in the support bracket under
control panel.
4