Ariens Sno-Tek 24E Manuel Du Propriétaire page 26

3
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Arm
4. Hairpin
Figure 24
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
WARNING: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. AUGER / IMPELLER MUST
STOP within 5 seconds when
attachment clutch lever is released.
WARNING: Adjustment procedure
requires the engine to be run with the
belt cover off. AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Remove Attachment Cable Slack
(Figures 25 and 26)
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Loosen hardware securing belt cover to
unit.
NOTE: DO NOT completely remove
hardware from unit.
3. Remove belt cover.
All manuals and user guides at all-guides.com
4
1
2
GB - 26
4. Loosen jam nut on cable adjustment
barrel, and then turn the adjustment
barrel down to shorten cable and
remove all cable slack (Figure 25).
1. Attachment Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
Figure 25
5. With the attachment clutch disengaged,
check that the attachment idler arm
lightly touches the frame (Figure 26).
6. Tighten jam nut on cable adjustment
barrel.
With the attachment clutch disengaged,
check the attachment idler arm position
here. The attachment idler arm should
lightly touch the frame.
Figure 26
1
2
3
OS8260
OS7188