Ariens Sno-Tek 24E Manuel Du Propriétaire page 30

6
2
4
1
1. Swing Gate
2. Swing Gate Spacer
3. Swing Gate Finger & Stop Hole
4. Drive Plate
5. Traction Idler Spring
6. Engine Sheave
7. Drive Plate Return Spring
Figure 34
6. Install new traction drive belt.
7. Swing drive plate toward friction disc
until finger lines up with stop hole in
frame. Slide the drive plate over,
inserting the finger into the stop hole.
8. Reinstall swing gate spacer
9. Reinstall traction idler spring.
NOTE: Make sure drive plate return spring
remains connected to the frame and drive
plate. Make sure the swing gate pivot bushing
is piloted in the pivot hole in the frame
10. Replace attachment drive belt (See
Replace Attachment Drive Belt on
page 28).
All manuals and user guides at all-guides.com
FRICTION DISC REPLACEMENT
Remove Friction Disc
(Figures 35 and 36):
5
3
7
NOTE: Be sure to save washers between
carrier bearing and speed selector arm for
reassembly.
GB - 30
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
CAUTION: Before tipping unit,
remove enough fuel so that no spills
occur.
2. Place the unit into the service position
on a level surface.
3. Remove lockpins from wheel axles and
remove wheels.
4. Remove bottom cover by removing six
hex bolts.
5. Disconnect adjustment pivot pin from
the speed selector arm. Save the
hardware for reinstallation.
1
2
3
5
4
6
1. Traction Drive Clutch Cable
2. Adjustment Barrel
3. Jam Nut
4. Adjustment Pivot Pin
5. Speed Selector Arm
6. Attachment Clutch Arm
Figure 35
6. Remove spring clip pin nearest drive
gear from hex shaft.
7. Remove left bearing flange from frame.
8. Slide hex shaft to the left to remove the
flat washer, pinion gear and friction disc
assembly from the hex shaft.
OS8175