Ariens Sno-Tek 24E Manuel Du Propriétaire page 16

IMPORTANT: If the belt squeals continuously
when the attachment clutch lever is engaged,
the impeller may be frozen in the auger
housing. Immediately release the attachment
clutch lever and move the unit into a heated
area to thaw.
NOTE: If belt squeals continuously when
impeller turns freely, see Attachment
Clutch/Brake Adjustment on page 26.
Ignition Switch
(Push/Pull Safety Key)
Key Switch has two
2
positions:
1. "Stop" – pulled out
2. "Run" – pushed in
NOTE: DO NOT twist key
1
after it is inserted.
Engine Shutoff Switch
1. Set the engine shutoff switch to the run
position ("Run") to start and operate the
engine.
2. Set the engine shutoff switch to the stop
position ("Stop") to shut off a running
engine.
Primer Bulb
Pushing the primer bulb in
adds fuel for easier engine
start. Refer to Starting and
Shut Off on page 19.
Speed Selector
Position the speed selector in the appropriate
speed notch to control forward and reverse
travel.
6
Forward:
(6) Fastest
(1) Slowest
Reverse:
(1) Slow
(2) Fast
IMPORTANT: DO NOT change motion from
forward to reverse with clutch engaged.
Forward speed can be changed without
declutching.
All manuals and user guides at all-guides.com
Fuel Shut-Off Valve
IMPORTANT: The fuel shut-off valve MUST
be in the closed position prior to transporting
the unit.
The fuel shut-off valve has two positions:
Choke Control
IMPORTANT: Gradually open choke after
engine starts.
Electric Starter
The electric starter will start a properly
choked and cranked engine when the starter
button is pushed. Refer to Starting and Shut
Off on page 19.
Recoil Starter Handle
When pulled, recoil starter handle will turn
engine over.
IMPORTANT: DO NOT let recoil starter
1 1 2
handle snap back against starter.
See Starting and Shut Off on page 19.
GB - 16
Open (1): Use this
OFF position to run the
unit.
2
Closed (2): Use this
position to service,
transport, or store
ON
1
the unit.
1. Choke Closed position: chokes off air to
engine for easier start.
2. Choke Open position: allows for normal
operation.
2
1
START
RUN