Transport - Ariens Sno-Tek 24E Manuel Du Propriétaire

Shut Off
1. Release traction drive clutch lever and
allow unit to come to a complete stop.
2. Run impeller a few minutes after use to
prevent freeze-up of impeller.
3. Release attachment clutch lever and
wait for all moving parts to come to a
complete stop.
4. Turn off the engine shutoff switch
("Stop").
5. Remove key.
All manuals and user guides at all-guides.com
SNOW REMOVAL
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperature before clearing
snow.
NOTE: Attachment clutch should be engaged
before traction drive clutch when throwing
snow.
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
Tips for Operation
Snow is best removed as soon as possible
after snow fall.
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and throw snow to each side, so snow
is not cleared more than once.
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
TRAVELING
To travel from one work area to another:

TRANSPORT

ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
GB - 20
1. Select speed control position and
direction.
2. Engage attachment clutch – right hand
lever.
3. Engage traction drive clutch – left hand
lever.
1. Press down on handlebars enough to
raise front of unit slightly off surface.
2. Engage traction drive clutch without
engaging attachment clutch.