Ariens Sno-Tek 24E Manuel Du Propriétaire page 12

All manuals and user guides at all-guides.com
4. Connect the chute crank to the pinion
gear on discharge chute with spring clip
pin.
5. Orient the chute and pedestal to its most
vertical position and tighten pedestal
hardware to 15 – 31 lbf-ft (20 – 42 N•m).
1. Chute Crank
2. Support Bracket
3. Pinion Gear
4. Spring Clip Pin
Figure 9
Install Remote Deflector Cable
(Figures 10 and 11)
1. Pull rubber seal cap away from snap
.
1
2
4
3
1. Mounting Hole
2. Snap Fitting
3. Rubber Seal
2. Install snap fitting into cable bracket's
3. Position rubber seal cap over the top of
4. Move deflector control lever to rear most
5. Attach cable eye to pin on bottom of
NOTE: Hold down chute deflector cap, if
needed, for more cable slack.
GB - 12
fitting (Figure 10).
5
3
1
2
4. Hairpin
5. Bushing
6. Cable Eye
Cap
Figure 10
mounting hole located under the control
panel.
snap fitting.
position.
deflector control lever.
6
4